Electricity basics
How to Calculate Appliance Electricity Cost
Calculate appliance running costs from watts or measured kWh. Keep cycling, electricity rates, fixed fees, and hot-water energy in the right places.
Multiply energy in kWh by your electricity price per kWh. Use measured energy when possible. Rated watts multiplied by time is an estimate for steady power.
On this page
An appliance's electricity cost depends on two things: how much energy it uses and what you pay for that energy. The purchase price and wattage label do not answer that question alone.
The EIA's electricity guide distinguishes power in watts from energy in kilowatt-hours. Your bill usually charges for the second. Start with the energy figure that best matches your actual use.
Choose the best energy figure
For a fridge, use measured kWh over several ordinary days. For a dryer, use energy for a complete load. For a buying comparison, an annual energy label can be useful.
Rated watts and running time are a fallback. They work best when power stays roughly constant. A heater, compressor, or motor may change its draw during operation. Treat an estimate from maximum power as an assumption, not a measurement.
- Write down the appliance and the period you want to estimate.
- Record measured kWh, cycle energy, annual label energy, or input watts.
- Check the variable electricity price on your tariff.
- Multiply energy by that price.
- Keep any missing costs beside the result.
Convert watts into energy
Use this formula when the entered watts represent the average power for the entered time:
kWh = watts ÷ 1,000 × hours
Suppose a hypothetical device uses a steady 500 W for four hours. It uses 500 ÷ 1,000 × 4 = 2 kWh. At an illustrative $0.20/kWh, that costs $0.40. Thirty identical days cost $12.
These numbers describe the example. They are not a typical dehumidifier rating or a current local electricity price. If the device draws power for only half the four hours, this steady-power estimate will be too high.
Use measured or label energy directly
If a monitor records 6 kWh over three days, the measured daily average is 2 kWh. Do not multiply it by watts again. Multiply the 2 kWh directly by your rate.
An annual label of 365 kWh suggests a standardized daily average of 1 kWh. The FTC explains that label costs use typical conditions and a national energy price. Recalculate with your price, but retain the label's usage limitations.
For a cycle appliance, multiply cycle kWh by the number of cycles. A hypothetical 0.8 kWh cycle used 20 times consumes 16 kWh. At $0.20/kWh, electricity for those cycles costs $3.20.
Keep the bill boundaries clear
Use dollars or other currency units per kWh, rather than cents. Enter 0.20 for 20 cents. Entering 20 would make the result 100 times too high.
A fixed monthly fee does not usually fall when one appliance uses less energy. Separate water heating may also sit outside a plug-in measurement. A washing machine can draw electricity while its hot water comes from another energy source.
On tiered or time-of-use tariffs, apply the rate for the energy you are evaluating. One average rate may hide those differences.
Make the result useful
Use the electricity cost calculator with your best input. Record the method next to the result. “Measured over seven days” is more useful than an unexplained monthly cost.
Change one assumption at a time. This shows whether runtime, energy per cycle, or the tariff drives the difference. Recheck after a seasonal change. A short measurement does not establish an appliance's use for the whole year.
Sources
Source pages checked during research on 7 October 2026. Examples are Handy Daily calculations unless stated otherwise.